Description
In this lab, you will start by building a “3-8 decoder”, a block diagram for which is shown in the figure below. The decoder has 3 inputs (in0, in1, in2) and 8 outputs (out0, out1, out2, out3, out4, out5, out6, out7). Based on the input values only one output will be set to 1 with the remaining outputs set to 0. For example, the first row in the truth table indicates that if the inputs to the decoder are in0=0, in1=0, and in2=0, then out0=1 and the remaining outputs are set to 0. If instead the inputs to the decoder are in0=0, in1=1, and in2=1, then the fourth row of the truth table indicates output out3=1 and the remaining outputs are set to 0.
a) Complete the truth table below.
In2
in1
in0
out0
out1
out2
out3
out4
out5
out6
out7
0
0
0
0
0
1
0
1
0
0
1
1
1
0
0
1
0
1
1
1
0
1
1
1
b) Implement the decoder behaviorally using Verilog, following the specifications in the truth table. Run a function simulation of the code. Using 3 switches for the inputs and 8 LEDs to display the outputs, implement the code using only primitives (AND, OR, NOT etc.) or their symbols ($, |, ~ etc.) on the DE10 board. Rewrite the code using a “case” statement.
Priority Encoders
A priority encoder is a “one-hot” encoder where each input has an associated priority level and the output identifies the input with the highest priority. The input with a high priority is asserted and the rest of the inputs are ignored.
c) Design a 8-3 priority encoder where the 8 inputs are encoded in order such that in[7] has the highest priority and in[0] has the lowest priority. The data is only valid if another output, z=1. If no inputs are selected (In=0), z=0. Start by filling out the truth table below.
In[7]
In[6]
In[5]
In[4]
In[3]
In[2]
In[1]
In[0]
Out[2]
Out[1]
Out[0]
z
𝑖0
𝑖1
𝑖2
𝑖3
𝑖4
𝑖5
𝑖6
𝑖7
d) Implement this circuit in Verilog using the row by row technique that was demonstrated in class. Create a Boolean expression for each row in the truth table. Calculate the output,
e) Now implement this circuit using a “casex” statement.
